Installation procedure of under vehicle inspection mirror
Vehicle inspection mirror is commonly used in daily life, then we will be using it, check the bottom mirror general in order to facilitate the delivery process, are used to send all parts by mail, and when we received the vehicle inspection mirror often don't know how to assemble, introduce the AT-9006S vehicle inspection mirror assembly steps and pictures!
1. Length adjustment of telescopic rod
firstly adjust seat wrench (below) to the direction of pulling out, the first section telescopic rod, then pull down the direction of adjusting wrench holder locking telescopic rod. Secondly,the regulation of card (as Tutu) wrench to the direction of pulling, pull second telescopic pole, then pull down the direction of adjusting wrench holder locking telescopic rod. The adjusted telescopic rod has a total degree of 3.1 meters.
2. Assemble the connecting parts of the camera and the telescopic rod
3. Complete assembly of machines
4, the connection of the signal line
After assembling the power box and the LCD to the telescopic rod, 1, the signal line of the LCD is inserted into the hole position of DISPLAY, 2, the signal line of the camera is inserted into the hole position of CAMERA, 3, the switch is shifted to ON, and the location is "open", and the OFF position is "shut".
Note: it can be opened after the confirmation is unmistakable!